Measurement applications
PCB & FPC
Dimensional Inspection
Review optical measurement for PCB and FPC outlines, hole patterns and visible component features. Plan fixtures, imaging and reporting around your drawing.
Start with the board features on the drawing
PCB and electronics inspection can involve very different tasks. This application review focuses on dimensional measurement: outlines, accessible hole patterns, pad positions and suitable visible component features. Electrical testing, solder-joint inspection and general automated optical defect inspection require their own defined methods.
For flexible circuits, the way the sample is supported can change the measured shape. Agree whether the drawing refers to a free-state part or a specified fixture condition. For larger panels, allow clearance for the board, fixture and loading movement as well as the nominal measuring travel.
| Inspection task | What to review | Setup considerations |
|---|---|---|
| PCB outline and holes | Visible perimeter, distances and hole locations | Confirm datums, edge definition, contrast and panel support. |
| FPC profile | Flexible outline and accessible features | Define the support condition and avoid stretching or flattening the sample differently between runs. |
| Pads and connectors | Visible positions, spacing and small features | Review finish, lighting, focus and optical access on real samples. |
Equipment routes to evaluate
Manual or semi-automatic review
For flexible setups or varied smaller batches, compare manual vision systems with the HVM S semi-automatic system. Confirm which steps remain operator controlled.
Repeat CNC inspection
Compare CNC vision measuring machines for repeated routines. Include alignment, fixture changes and report preparation when assessing cycle time.
Larger panel envelopes
Review the Gantry series when the workpiece envelope needs a larger arrangement. Check travel, loading access and the supported measurement functions.
A practical application review
- Mark the required features, datums and tolerances on the drawing.
- Provide rigid and flexible samples with representative surfaces and edge conditions.
- Review fixturing, illumination and a repeat measurement after unloading and reloading.
- Agree the report fields, inspection routine and model-specific acceptance criteria.
Include the part drawing, material and finish, representative samples, expected inspection volume and any data-export requirements. Record difficult or uncertain features so the review can address them directly.
For practical method guidance, read PCB and FPC measurement planning guide. The selected configuration and measurement conditions should be confirmed through the application review.
Questions before selecting equipment
Does a vision measuring machine replace PCB AOI?
Not automatically. Dimensional measurement and defect inspection are different requirements. List the required checks so the method and software can be assessed against each task.
Can flexible circuits be measured?
Suitability depends on sample support, visible features and the required tolerance. Send the expected fixture condition and representative samples for evaluation.
More practical guidance
Discuss your inspection task
Share a drawing or annotated image, the features and tolerances, sample dimensions and expected inspection volume. We can then review a suitable configuration.